Dual Channel 4-port OHCI 1.2 Compliant FireWire 800 (IEEE 1394b) to PCI Express Host Adapter

The FWBX2-PCIE1xE220 is a Dual OHCI 1.2 Compliant FireWire 800 (IEEE 1394b) to PCI Express Host Adapter.

FWBX2-PCIE1xE220 is designed with Two key components.
   * 3-Lane, 3-Port PCI Express Switch.
   * OHCI 1.2 Compliant IEEE 1394b Single Chip Host Controller.

Utilizing the standard PCI Express Switch, the 3-Lane/3-Port PCI Express Switch provides the most efficient fan-out solution for integrating two OHCI 1.2 Compliant IEEE 1394b Single Chip Host controllers into a small board design. Each OHCI 1.2 Compliant IEEE 1394b Single Chip Host controller takes advantages of 2.5 Gbps burst rate of 1-lane PCI Express bus in both directions and is fully compliant with PCI Express Base specification 1.1. This solution provides full PCI Express and 1394b functionality and performance.

PCI Express:  
   * Fully compliant with revision 1.1 base specification.
   * One virtual channel.
   * Eight traffic classes.
   * 64-bit and 32-bit platform support.
   * PCI compatible Interrupts via legacy INTx emulation

OHCI (Open Host Controller Interface):
   * Enhanced with the OHCI 1.2 draft specification for 1394b-2002 PHY full operational compliance.
   * OHCI 1.0 backwards compatible. Configurable via EEPROM to operate in either OHCI 1.0 or OHCI 1.1 mode.
   * 8 Kbyte isochronous transmit FIFO.
   * 4 Kbyte asynchronous transmit FIFO.
   * 8 Kbyte isochronous receive FIFO.
   * 8 Kbyte asynchronous receive FIFO.
   * Dedicated asynchronous and isochronous descriptorbased DMA engines.
   * Eight isochronous transmit contexts.
   * Eight isochronous receive contexts.
   * Supports parallel processing of incoming physical read and write requests.

1394b-2002 PHY:
   * Provides three IEEE® 1394b-2002 compliant ports supporting 1394b-2002 speeds of 800 Mbits/s and 400 Mbits/s while main- taining backward compatibility to IEEE 1394a-2000 speeds of 100 Mbits/s, 200 Mbits/s, and 400 Mbits/s over 4.5 m copper.
   * Fully supports provisions of IEEE 1394a- 2000 and 1394-1995 standards for high- performance serial bus.
   * Link is not required for hub operation.
   * Supports extended BIAS_HANDSHAKE time for enhanced interoperability with cam- corders.
   * Does not require external filter capacitor
     for PLL.
   * Supports arbitrated short bus reset to improve utilization of the bus.
   * Supports ack-accelerated arbitration and fly-by concatenation.
   * Supports PHY pinging and remote PHY access packets.
   * Fully supports suspend/resume.

FireWire P1394b Cable Ports :
FWBX2-PCIE1xE220: Four FireWire P1394b Cable Ports
   * OHCI 1: Two 1394b Bilingual Ports
   * OHCI 2: Two 1394b Bilingual Ports

Power Management:
   * Supports PCI Power Management Interface specification (PCI-PM 1.2)
   * Supports Advanced Configuration and Power Interface Specification, Revision 2.0 (ACPI) supporting active link state.

Bus Power Connector:
   with IDE big 4-pin DC +12V power connector

Operating System Requirements
   * Windows 2000, XP, 2003
   * Linux 2.6.X
   * Mac OS X

Výrobek je dodáván s manuálem pouze v anglickém nebo německém jazyce.